Operating A Tv With The Remote Control - Toshiba SD-5970SC Owner's Manual

Others

Operating a TV with the Remote Control

You can operate the basic functions of selected TVs using the supplied remote
control
Operating a TV with the remote control
Preparation
Follow the instruction of "To program the remote control" to set the brand code.
Point the remote control at your TV, and use
buttons as follows.
POWER
INPUT SELECT
NUMBER buttons
100
DISPLAY
VOL + / -
CH +/ -
ENTER
POWER
INPUT SELECT
Numbers/100
DISPLAY
CH, VOL
ENTER
60
To turn the TV on or off.
To select external source
such as a VCR.
To select TV channel. When
selecting channels 1 to 9,
first enter 0 and then the
desired number.
To substitute for 100
channel key.
To turn on or off TV's screen
display.
To adjust the volume.
To select a channel.
To use for the TV's ENTER
key.
To program the remote control
1. Press TV to select TV mode.
2. While holding down PROGRAM enter the two digits
of your TV's brand code (listed on page 61) using
Number buttons.
e.g. To program brand code 01.
0
3. Release PROGRAM.
The DVD remote control memorizes the selected
TV brand code.
Notes
• The remote control is programmed at the factory to operate
TOSHIBA TVs.
• A single brand may use different codes depending on the
particular model. Enter the correct number referring to the
brand code table.
• For some brands, several brand codes are provided. Try
each of them until the remote control operates your TV.
• Some TVs may not respond to all of the functions in the
table above, or may not be operated at all with this remote
control.
• If you replace the remote control's batteries, remember to
reprogram the brand codes for TV.
• To resume DVD functions, press DVD button once.
1