Interference Or Static; Changing The Ringer Volume; Changing The Handset Speaker Volume - Toshiba FT-8001 A Owner's Manual

3. INTERFERENCE OR STATIC

If you hear noise during a call, press
The TALK/BATT LOW LED blinks while changing a channel.

4. CHANGING THE RINGER VOLUME

Press
VOL/RING
during standby mode.
Each time you press

5. CHANGING THE HANDSET SPEAKER VOLUME

During a telephone call, press
volume levels; Low, Medium and High.
The setting will remain in effect even after you hang up the current call.
Note
The High setting may be too loud because it is set for hearing aid compatibility.
6. REDIALING
Press and then press
TALK
called (up to 32 digits) will then be dialed again.
7. USING THE CALL WAITING SERVICE, ETC.
To use this feature, you must subscribe to the Call Waiting service.
When you hear a call-waiting tone while you are already talking on the
phone, simply press
To take the original call back, press
Note
Pressing without receiving a Call Waiting signal may disconnect the current caller.
FLASH
to select one of four ringer tone and volume combinations
VOL/RING
RDL/P
.
FLASH
to select another channel.
CH
, the setting will change.
to select one of three speaker
VOL/RING
(Redial/Pause). The last number
again.
FLASH
12