OPERATING CONTROLS HANDSET CONTROLS AND FUNCTIONS ANTENNA LINE 2 LED (Orange) LINE 1 LED (Green) TALK/BATT LOW LED (Red) SPEED DIAL INDEX LINE 1 button TALK button TALK LINE1 LINE2 LINE 2 button BATT LOW SPEED DIAL INDEX TALK TONE button Dialpad (0~9, and # buttons) LINE1...
ALIGNMENT PROCEDURE Base Unit BASE Unit AF GEN. Test Point Transmitter Section Power Meter Connections DC IN TEL Line 1kHz 77.5mV 9V Jack Jack Test Point Frequency Counter AC 120V Adapter 60Hz Deviation Mater Preset a) Connect the base RF unit to the base main unit. b) Connect the AC adapter to the base unit while pressing the “...
Page 5
Receiver Section Connections BASE Unit AC Voltmeter RF SG Dummy Load (600-ohm) TEL Line Test Point Jack DC Voltmeter DC IN 9V Jack Terminal AC 120V 60Hz Adapter Preset a) Connect the base RF unit to the base main unit. b) Connect the AC adapter to the base unit while pressing the “...
Page 6
Handset Unit Transmitter Section Connection HANDSET Unit AF GEN. Test Point Power Meter J603 Battery 1kHz 11mV MIC+Pin Connector Test Point Frequency Counter DC Power Supply Deviation Mater DC 3.8V Preset a) Connect the handseet RF unit to the handset main unit. b) Connect DC power supply to battery connector on the handset unit.
Page 7
Receiver Section Connections HANDSET Unit AC Voltmeter RF SG Dummy Load (150-ohm) Test Point Terminal DC Power Supply J603 DC Voltmeter Battery Test Point Connector DC 3.8V Preset a) Connect the handset RF unit to the handset main unit. b) Connect DC power supply to battery connector on the handset unit. c) Turn the DC power supply ON while pressing “...
TROUBLESHOOTING HINTS 1. The bell does not ring. See 2. The bell does not ring When the INTCOM key of the & page does not ring. base is pressed, does the ringer on the handset ring? When the TEL SG is joined Check IC5 (Line1) or IC13 with the base to make bell (Line2) and TEL network...
Page 14
2. The bell does not ring & page does not ring. Can the base and handset be See 3. The base and handset connected? cannot be connected. Press handset DIAL key When the key of the handset is Check IC603. while in TALK MODE.
Page 15
3. The base and handset cannot be connected. Check whether the base Check IC14 and its is able to set in the test peripheral circuit. mode 1. Check the TX POWER Check base RF unit. and the TX FREQUENCY on the base unit. Set the base in the test Check whether there is a Check RT2, R69, R70,...
Page 16
Set the handset in the Check whether there is a Check RT603, R619, test mode 3, check 250 Hz data waveform at R632, R634, R635, whether deviation of the “MOD” of RF unit. R636 and C610. TX data is app. 8 kHz Dev.
Page 17
4. Cannot make a phone call (pulse). Can the base and handset See 3. The base and handset be connected? cannot be connected. While in TALK MODE, press Check IC5. dial key of the handset. Check whether square wave- form from pin 89 (Line1) or pin 90 (Line2) of IC14 is fed.
Page 18
6. Voice cannot be transmitted to other party (outgoing call). Can the base and handset be See 3. The base and handset connected? cannot be connected. T h e 1 k H z , 1 1 m V s i n e Check Q608 and its wavefor m i s a p p l i e d t o peripheral circuit.
Page 19
7. The voice of the caller cannot be heard (incoming call). Can the base and handset be See 3. The base and handset connected? cannot be connected. The 1 kHz, 77.5mV sine Check the base TEL-line waveform is applied to TEL- circuit and REPLAY control line of the base, can the 1 kHz circuit.
Page 20
8. Trouble with intercom mode. 8-1. The voice from the Base unit cannot be heard on the Handset. Check whether there is an Check MC1 and IC17. audio waveform on pin 4 of IC17. Check pin 8 of IC15. 8-2. The voice from the Handset cannot be heard on the Base unit. Check whether there is an Check IC15.
Page 21
9. Trouble with speakerphone mode. 9-1. The voice of the caller cannot be heard (INCOMING CALL). Check whether there is an Check IC8 (Line1) or IC15 audio waveform on pin 11 of (Line2). IC8 (Line1) or pin1 of IC15 (Line2). Check whether there is an Check IC7.
IC AND TRANSISTOR VOLTAGE CHART Base Unit Unit[V] Unit[V] Ref. No. PIN STBY TALK NOTE Ref. No. PIN STBY TALK NOTE OPEN OPEN 0.2-4.9 0.2-4.9 PULSE OPEN OPEN OPEN...
Page 23
Unit[V] Unit[V] Ref. No. PIN STBY TALK NOTE Ref. No. PIN STBY TALK NOTE OPEN OPEN OPEN OPEN OPEN OPEN 0.0-3.0 PULSE / -- 3.0-0.0 PULSE / -- 3.0-0.0 PULSE / -- IC10 0.0-3.0 PULSE / -- IC11 OPEN OPEN OPEN IC14 IC12...
Page 24
Unit[V] Unit[V] Ref. No. PIN STBY TALK NOTE Ref. No. PIN STBY TALK NOTE 0.1-4.9 0.1-4.9 PULSE IC14 OPEN OPEN OPEN IC15 2.2Vp-p 2.2Vp-p SINE WAVE 1Vp-p 1Vp-p SINE WAVE 4.1Vp-p 4.1Vp-p OPEN(SIN) OPEN OPEN OPEN IC14 AVCC VREF IC17 0.0-3.8...
Page 25
Unit[V] Unit[V] Ref. No. PIN STBY TALK NOTE Ref. No. PIN STBY TALK NOTE IC17 IC18 1Vp-p 1Vp-p SINE WAVE 0.5Vp-p 0.5Vp-p SINE WAVE IC181 OPEN Q181...
PARTS LIST PRODUCT SAFETY NOTE : Products marked with a have special characteristics important to safety. Before replacing any of these components, read carefully the product safety notice of this service manual. Don't degrade the safety of the product through important servicing. Symbol Symbol ±...
Page 41
LOC. REF. PART NO. DESCRIPTION RC005216 BCMM813304Z CERAMIC M/L (1608) TAPE 33PF 50V J CH RC005202 BCML311045Z CERAMIC M/L (1608) TAPE 0.1UF 16V K B RC005202 BCML311045Z CERAMIC M/L (1608) TAPE 0.1UF 16V K B RC005208 BCML814725Z CERAMIC M/L (1608) TAPE 0.0047UF 50V K B RC005102 BCAP814796Z...
Page 42
LOC. REF. PART NO. DESCRIPTION RC005275 BCML813925Z CERAMIC M/L (1608) TAPE 0.0039UF 50V K B RC008925 BCMF311040Z CERAMIC M/L (1608) TAPE 0.1UF 16V Z F RC004947 BCAP314706Z ELECTROLYTIC 47UF 16V M C-130 RC005205 BCML811035Z CERAMIC M/L (1608) TAPE 0.01UF 50V K B RC004945 BCAP111016Z ELECTROLYTIC...
Page 43
LOC. REF. PART NO. DESCRIPTION C150 RC005102 BCAP814796Z ELECTROLYTIC 4.7UF 50V M C-130 C151 RC005102 BCAP814796Z ELECTROLYTIC 4.7UF 50V M C-130 C152 RC004952 BCAP811096Z ELECTROLYTIC 1UF 50V M C-130 C153 RC004947 BCAP314706Z ELECTROLYTIC 47UF 16V M C-130 C154 RC004947 BCAP314706Z ELECTROLYTIC 47UF 16V M C-130 C155...
Page 44
LOC. REF. PART NO. DESCRIPTION C608 RC008754 BCMM813098Z CERAMIC M/L (1608) TAPE 3PF 50V B CH C609 RC008296 BCSH901006Z TANTALUM CHIP TAPE 10UF 6.3V M C-122 C610 RC008006 BCML811525Z CERAMIC M/L (1608) TAPE 0.0015UF 50V K B C613 RC005202 BCML311045Z CERAMIC M/L (1608) TAPE 0.1UF 16V K B C614...
Page 45
LOC. REF. PART NO. DESCRIPTION C658 RC005207 BCML813325Z CERAMIC M/L (1608) TAPE 0.0033UF 50V K B C659 RC005205 BCML811035Z CERAMIC M/L (1608) TAPE 0.01UF 50V K B C660 RC008319 BCSH904796Z TANTALUM CHIP TAPE 4.7UF 6.3V M C-122 C661 RC005202 BCML311045Z CERAMIC M/L (1608) TAPE 0.1UF 16V K B C662...
100×100×0.1T RC008423 VNYL3102500 VINYL BAG 100×250×0.1T ASSEMBLY PARTS LIST NOTE: Following part numbers are not available as replacement parts. Order parts necessary for repair or contact the Toshiba Factory Service Center. LOC. REF. PART NO. DESCRIPTION RC008545 AC230BLBA MAIN PCB ASSEMBLY, BASE...