Table of Contents
Advertisement
-
Do not use an extension
cord
-
IMPORTANT:
relevant to the voltage and
power
absorption
indicated
on
plate.
Assembly
After having cleaned the perimeter
surface, apply the supplied gasket to
the hob. Position the hob in the
worktop opening made respecting the
dimension s indicated in the instruction.
NOTE: the power supply
cable must be long enough
to
permit
its
extraction.
To secure the hob, use the brackets
provided with it. Fit the brackets into
the relevant bores shown by the arrow
and fasten them by means of their
screws
in
accordance
thickness of the worktop.
Make sure that the outlet is near the
product to install. So, if the cable that
came with the product is not long
enough, you will need to replace it with
another one having the same features
but with the right length.
Adjustment to different type of gas
WARNING
-
This operation must be performed
by a qualified technician.
If the appliance is intended to operate
with a different gas from the gas type
stated
on
the
information label on the top of the
hob, change the injectors.
Remove the information label and keep
it with the instructions booklet.
the
data
are
the
rating
upward
with
the
rating
plate
and
Use pressure regulators suitable
for the gas pressure indicated
in the Instruction.
-
The gas nozzles must
changed by After Sales Service
or a qualified technician.
-
Nozzles not supplied with the
appliance must be ordered
from After Sales Service.
-
Adjust the minimum setting of
the taps.
NOTE: when liquid petroleum gas is
used (G30/G31), the minimum gas
setting screw must be tightened as far
as it will go.
IMPORTANT: should you experience
difficulty in turning the burner knobs,
please contact the After Sales Service
for the replacement of the burner tap if
found to be faulty.
Replacing the injectors
(see paragraph "injector table")
-
Remove grids (A).
-
Extract burners (B).
-
Using a socket spanner of the
appropriate size unscrew the
injector
(C),
injector to be replaced.
-
Replace
it
injector suitable for the
new type of gas.
-
Re-assemble the injector in (D).
Before
installing
remember to affix the gas
calibration plate supplied with
the injectors in such a way
that it covers the existing
information relating to gas
calibration.
12
be
unscrew
the
with
the
the
hob,
Advertisement
Table of Contents
