Table of Contents
Advertisement
Installation
In order to prevent damage of the
product,
please
stabilizer.
After unpacking the hob, make sure that
it has not been damaged during transport.
In the event of problems, contact the
dealer or your nearest After-sales Service.
Technical information for the installer
-
This product can be embedded in
a worktop 8 to 40 mm thick.
-
Before installation, make sure that:
The local gas delivery conditions
(nature and pressure) are compatible
with the settings of the hob (see the
rating plate and injector table)
-
"Reference to Local Regulations".
If no information concerning your
Country is given, please ask
details to a qualified technician.
-
To avoid excessive overheating, a
separation sector is needed to
secure 100 mm distance between
bottom of gas hob and the object
below
-
The connection of the hob to the
gas pipe network or gas cylinder
must be made by means of a
rigid copper or steel pipe with
fittings
complying
regulations, or by means of a
continuous-surface stainless steel
hose
complying
regulations. The maximum length
of the hose is 2 linear metres.
use
the
voltage
with
local
with
local
-
This appliance is not connected
to a fume exhaust device. It shall be
installed in accordance with current
installation
attention shall be given to the relevant
requirement regarding ventilation.
-
Combustion products are discharged
outdoors through specific hoods or wall
and/or window mounted electrical fans.
-
The outer surface of the furniture or
appliances adjacent to the hob are heat
resistant according to local regulation
Gas connection
This operation must be performed
by a qualified technician.
The gas supply system must comply
with local regulations to the relevant
gas standard.
IMPORTANT:
stainless steel hose is
used, it must be installed
so as not to touch any
mobile
furniture.
It must pass through an
area where there are no
obstructions and where it is
possible to inspect it on all
its length.
-
After connection to the gas
supply, check for leaks with
soapy water. Light up the
burners and turn the knobs
from max position
minimum
check flame stability
Electrical connection
WARNING
-
This
operation
performed
technician.
-
The electrical connections must
comply with local regulations.
-
The earthing of this appliance is
compulsory by law.
regulations.
Particular
if
a
part
of
the
to
position
to
must
by
a
qualified
11
be
Advertisement
Table of Contents
