Fine Tuning; Aerial; Memory Functions - Silvercrest KH 2029 Operating Instructions Manual

Setting the MW band
Since the radio transmitter systems differ from one
country to another, you should make the appro-
priate setting via the reception range setting:
MODE
• Press the button six times and then use the
UP DOWN
or button to select the corresponding
reception range as per the following table:
Region Channel spacing Band range
America 10 kHz
Europe 9 kHz

Fine tuning

If a station can not be found precisely the fine
tuning can be use to improve reception.
• During the channel search press the
button, the screen shows FINE.
UP DOWN
• The and buttons can now be used to set
the desired frequency in half frequency steps.
FINE
• By pressing the
tuning function again.
This function is not available for the LW frequency
range.

Aerial

The rotatable telescopic aerial on the radio can be
used for the FM and SW bands.
• Pull the aerial out fully and arrange it for
optimum reception.
SW SEN.
The switch on the left side of the device
can be used to improve the reception quality for
the SW band. Select LX for strong stations and RX
to improve reception for weak stations.
520–1710 kHz
522–1656 kHz
FINE
again you leave the fine
The telescopic aerial does not work in the MW and
LW bands. In these bands, the radio uses its built-in
ferrite aerial.
• Align the radio for best reception.

Memory functions

Save station
The world receiver can save 400 stations in each
frequency range.
To store a station, proceed as follows:
• Set the frequency range with the frequency
selection switch and then the station that you
want to save (see above).
MEM
• Press the
PAGE memory page and MEM flashes.
• Within 10 seconds press the
(the PAGE message flashes), and then select
a memory page (from 00–39) using the
DOWN
or button.
• Within 10 seconds use the
to select a memory space to store the station. For -
example, press the
space 0 and again for memory space 5. The oc-
cupancy is shown on the screen.
MEM
• Press again to save the station. The PAGE
and MEM messages are shown on a perma-
nent basis.
Note:
If the world receiver is connected to the mains
adapter and no batteries have been inserted,
the station memories are lost when the adapter
plug is pulled from the socket.
- 12 -
button. The screen shows the
PAGE
button
M.0/5 M.4/9
–
M.0/5
button once for memory
UP
buttons