Jacuzzi SWIMSPA Series Owner's Manual page 17

WARNING:
Fill the swim spa with clean tap water from garden hose, to reduce the risk of con-
tracting a waterborne illness (e.g. an infection, bacteria or virus) and/or respirato-
ry ailments. Fill until water covers all the jets but does not touch the bottom of the lowest
headrest (DO NOT OVERFILL!).
:
IMPORTANT
to do so may cause air to be trapped in the pumps, preventing the pumps from circulating
water. Remove the hose and replace both filter cartridges as illustrated in Section 13.1.
3. Turn On Power
Turn on the power to the swim spa at the home's circuit breaker. The heater and fil-
ter/circulation pump will automatically activate. Normally, at the initial fill, the water
tends to be cold.
4. Activate Jet Pumps
Turn on jet pumps when adding chemicals in step 5 (see section 11.2)
5. Add Start-Up Chemicals
Add the swim spa water chemicals as recommended by your authorized Jacuzzi swim
spa dealer. See section titled "Water Quality Maintenance" for general guidance.
WARNING
Never leave chemicals opened and accessible to anyone. Use chemicals according
to the vendor's instructions. Always store chemicals in a safe and/or locked loca-
tion. Keep away from and out of reach of children.
6. Establish A Stable Sanitizer Reading
Establish a stable sanitizer reading of no less than 2.0 ppm free bromine or no less
than 1.0 ppm free chlorine. To ensure healthy water conditions, always maintain a
constant sanitizer reading within the levels recommended on the inside cover of this
manual. If sanitizer levels cannot be stabilized, perform the decontamination proce-
dure steps 9-15 on the following pages.
Note: The "Decontamination Procedure" should also be used after the swim spa has been
"Winterized" (Section 13.8) or has been sitting without power for an extended period.
TO DECREASE RISK OF INFECTION AND DISEASE.
Always fill your swim spa through both filter fittings after draining. Failure
: RISK OF POISONING OR DEATH.
17