Toshiba CARRIER RAV-SP240UT-UL Owner's Manual page 15

4-way Air Discharge Cassette Type
Set louver direction
1
Push during operation.
The louver direction changes with every push of
the button.
In HEAT operation
Direct the louver downward.
In COOL/DRY operation
Direct the louver horizontally.
In FAN operation
Select a desired louver direction.
Start swing operation
1
Push , set the louver direction to the
lowest position, and then push
SWING is displayed and the louvers swing
automatically.
Display during swinging
Repeat
Initial setup
Initial setup
Initial setup
again.
Stop swing operation
1
Push at a desired position while the
louver is swinging.
• When
direction can be set again from the highest
position.
• In COOL/DRY mode, the louver does not stop
as it directs downward. If stopping the louver as
it directs downward during swing operation, it
stops after moving to the third position from the
highest position.
Display when stopping the swing
Unit select
• When multiple indoor units are controlled with one
remote control, louver position can be set for all
indoor units or each indoor unit individually.
• To set louver direction for a particular unit, push
button to display an indoor unit number in the
control group. Then set the louver direction of the
displayed indoor unit by following the steps outlined
above.
• When no indoor unit number is displayed, all indoor
units in the control group can be controlled
simultaneously.
• Each time you push
the display changes as follows:
UNIT No.
1-1
Not
display
– 14 –
Owner's Manual
Unit select button
1
is pushed after that, the louver
FAN/HEAT COOL/DRY
operation operation
(left side of the button),
UNIT No. UNIT No.
1-2 1-3
UNIT No.
1-4
EN
14-EN