Operation As A 3D Scanner - Roland ZSC-1 User Manual

2-1 Operation As a 3D Scanner

Operation As a 3D Scanner
Startup
To Start Scanning
Confirm that the SCANNING light comes on.
Confirm that the VIEW lamp goes dark.
During scanning, never open the front cover.
You can pause scanning by pressing the VIEW button.
[MDX-40A]
Pressing and holding the VIEW button resumes operation.
[MDX-40, TS-30]
Pressing the VIEW button a second time resumes operation.
You can open the front cover while operation is paused.
Operation During the Scanning Mode
The SCANNING light comes on when the machine is in the scanning mode.
The machine automatically changes to the scanning mode when the sensor unit is installed and to the
modeling mode when the spindle unit is installed.
The operation of other buttons and controls is identical both in the scanning mode and in the modeling
mode. Refer to the documentation included with the modeling machine.
When in the scanning mode, the "operation-panel screen(VPanel)" cannot be used.
16
Close the front cover.
Switch on the main power switch.
The POWER light comes on.
Press the Sub power button.
The machine starts up, and initialization is per-
formed.