Select Slope Factor; Select Sprinkler Location - Toro 24 User Manual

Select Slope Factor

The SlopeFactor is an important component used in the automatic
watering program calculation to determine the amount of run time and
number of repeat cycles required per watering day.
The Slope Factor options are as follows:
• 0 – 5% Grade
None/Slight
• 6 – 8% Grade
Gentle
• Mild 9 – 12% Grade
1. Turn the Upper Line knob to select Set Slope Factor.
SET SLOPE FACTOR
None/Slight
2. None/ Slight (0 –5%) grade is selected by default. To select
an alternate Slope Factor, turn the Lower Line knob.
Note: To prevent runnoff, selecting any slop factor other than
None/Slight will result in a decrease in station run time per
cycle and an increase in the watering cycle frequency.

Select Sprinkler Location

Note: If a Slope Factor of None/Slight is selected, Sprinkler Location
setting is not enabled.
1. Turn the Upper Line knob to select Sprinklr Location.
SPRINKLR LOCATION
None, No Slope Set
2. None, No Slope Set is selected by default. To choose an
alternate Sprinkler Location, turn the Lower Line knob
to select one of the following options:
• All Parts of Slope (default if Slope Factor is other than None)
• Top of Slope
• Middle of Slope
• Bottom of Slope.
• Moderate 13 – 20% Grade
• Steep >20% Grade.
STA 01
0-5% Grade
STA 01
31