Caller Id/Clip; Setting The Date And Time - Topcom BUTLER 1200C User Manual

HANDL. B1200C/1210C
Butler 1200C/1210C
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• 'BASE -' appears on the display.
• Enter the number of the base unit you want to select (1-4). Use the number keypad.
• Press the Programming key
• 'SEARCHING' and the symbol
• A signal sounds once the selected base unit has been found.
Notes :
•
Before you can select a base unit, the base unit must be subscribed to the handset first.
•
If 'NOT SUB' appears on the display, this means the selected base unit does not exist or the handset has
not been

5 CALLER ID/CLIP

This function depends on de base unit to which the handset has been registered.
Some functions will not work as described below because it is possible that the base doesn't
support these functions.
The functions described below are in case the handset has been registered to the Topcom
Butler 1010 base.
(This service only works when you have a Caller ID/Clip subscription. Contact your telephone
company).
When you receive a call, the telephone number of the caller, the date and time appears on the
handset display. The telephone can receive calls in both FSK and DTMF. If the name is program-
med in the Phone Book, the name in the Phone Book is displayed!
The telephone can store 30 calls in a Call List that can be reviewed later. The telephone never
stores the same call twice. When the memory is full, the new calls automatically replace the
oldest calls in the memory. The symbol
answered. If the Call List is empty and you press the Up key
You can view the information of an incoming call as follows:
• Press the Up key
of the caller, the sequence number of the call in the Call List, the date and time of the call
appear on the display.
• Press the Down key

5.1. Setting the date and time

When you receive an incoming call and the date and time are not sent together with the
telephone number, this means that the date and the time will not be shown on the display.
30-03-2001 08:32
.
repeatedly until 'MANUAL' appears on the display.
.
.
appear on the display.
on the display blinks if the call is not read or not
. The name (if sent by the network or present in the Phone Book memory)
. The telephone number of the caller appears on the display.
60
Page 60
, three beep tones will sound.