Commissioning The Pac Profibus Expansion Module (840D Sl) - Siemens SINUMERIK 840D sl Ctrl-Energy System Manual

Ctrl-E Analysis
3.1 SENTRON PAC3200/4200
Parameterizing SENTRON PAC
You have the option of parameterizing the measuring device in the following ways:
● Using the input keys and display of the SENTRON PAC
● Using a PC connected to the SENTRON PAC, which has the software this has been
supplied (powerconfig).
After booting select the language and the measuring device is then ready for operation.
3.1.3

Commissioning the PAC PROFIBUS expansion module (840D sl)

To communicate via Profibus, the SENTRON PROFIBUS module in combination with Sentron
PAC3200/4200 must be parameterized differently.
1. Select SENTRON PAC "Settings" > "PROFIBUS modules".
- OR -
For SENTRON PAC4200, select "Settings" > "Expansion modules" > "MOD1" >
"PROFIBUS MODULE".
2. Press "Enter".
You obtain the following information in the subsequent window:
– Order number
– Serial number of the SENTRON PROFIBUS module
– Firmware version of the SENTRON PROFIBUS module
– PROFIBUS ADDR.:
3. Press "Enter".
This means that you have the option of entering the same PROFIBUS address as in the
automation system.
14
The DP address of module is displayed here.
System Manual, 01/2015, 6FC5397-0EP40-5BA2
Ctrl-Energy