Table of Contents
Advertisement
Troubleshooting
13 Troubleshooting
Symptom
No display
No tone
The icon
flashes
Base or handset do not ring The ringing volume is off or
Not possible to transfer a
call on PABX
Telephone does not react
to pressing the keys
14 Technical dataTechnical characteristics
Standard
Frequency range
Number of channels
Modulation
Speech coding
Emission power
Range
Number of handsets
Base power supply
Handset Batteries:
Handset autonomy
Handset talk time
Normal conditions of use
Dialling mode
Flash time
Measurements base
Measurements handset
Weight base with adaptor
Weight base without adaptor
Weight handset with batteries
34
Possible cause
Batteries uncharged
Handset turned OFF
Telephone cord badly
connected
The line is occupied by
another handset
Handset out of range
The base has no power supply Check the mains connection to the
The handset is not registered
on the base
low
The Flash Time is too short or
too long
Manipulation error
DECT(Digital Enhanced Cordless Telecommunications)
GAP (Generic Access Profile)
1880 MHz to 1900 MHz
120 duplex channels
GFSK
32 kbit/s
10 mW ( average power per channel )
300m in open space /50m maximum in-house
Up to 5
230V / 50 Hz / 6,5V DC 300mA
2 rechargeable batteries AAA, NiMh 1,2V, 750mA
110 hours in standby
11 hours
+5 °C to +45 °C
Pulse / Tone
100 or 250 ms
ca. 112mm x 112mm x 64mm (L x B x H)
ca. 34mm x 52,5mm x 154mm (L x B x H)
ca. 319g
ca. 135g
ca. 124g
Solution
Check the position of the batteries
Recharge the batteries
Turn ON the handset
Check the telephone cord
connection
Wait until the other handset hangs
up
Bring the handset closer to the base
base
Register the handset on the base
Adjust the ringing volume
Change the Flash Time
Remove the batteries and put them
back in place
Advertisement
Table of Contents
