Troubleshooting - Topcom Butler 2505 C User Manual

HANDL. B2505C_10_C_v3.qxd 28-01-2003 11:15 Page 29
Try again by changing the base number and check that you are not in a
environment where there is interference. Move closer to the base.
4.2 SETTING UP A BUTLER HANDSET ON ANOTHER BASE
If you want to use a Butler 2505C or Butler 2510C handset with a base of another
model. The base must be GAP compatible.
1. To put the base in registration mode, refer to the base user manual.
2. Carry out operations 3 to 10 from the paragraph 4.1.
5. TROUBLE SHOOTING
Symptom
No display
No tone
The icon
flashes
Telephone does not Manipulation error
react to pressing
the keys
Topcom Butler 2505C/2510C
Possible cause
Batteries uncharged
Handset turned OFF
Telephone cord badly
connected
The line is occupied by
another handset
Handset out of range
The base has no power
supply
The handset is not
registered on the base
ENGLISH
Solution
Check the position of the
batteries
Recharge the batteries
Turn ON the handset
Check the telephone cord
connection
Wait until the other handset
hangs up
Bring the handset closer to the
base
Check the mains connection to
the base
Register the handset on the
base
Remove the batteries and
but them back in place
29