Table of Contents
Advertisement
Operating and indicator panel
°C
ON/OFF
A
B
C
A.
Mains pilot indicator (green)
B
Fridge button ON/OFF
C
Temperature setting button (for warmer temperatures)
D
Temperature display
E
Temperature setting button (for colder temperatures)
F
COOLMATIC function "on" indicator (yellow)
G
COOLTMATIC button
Temperature setting buttons
The temperature is adjusted using the „C" (+) and „E" (-) buttons. These but-
tons are connected to the temperature display.
•
The temperature display is switched over from the display of the ACTUAL
temperature (Temperature display is illuminated) to the display of the DESI-
RED temperature (Temperature display flashes) by pressing one of the two
buttons, „C" (+) or „E" (-).
•
Each time one of the two buttons is pressed again the DESIRED temperatu-
re is adjusted by 1 °C. The DESIRED temperature must be reached within 24
hours.
If neither button is pressed, the temperature display automatically switches
back after a short period (approx. 5 sec.) to the display of the ACTUAL tem-
perature.
DESIRED temperature means:
The temperature that has been selected for inside the fridge. The DESIRED
temperature is indicated by flashing numbers.
ACTUAL temperature means:
The temperature display indicates the current temperature inside the fridge.
The ACTUAL temperature is indicated with illuminated numbers.
24
All manuals and user guides at all-guides.com
°C
D
E
F
G
Energy Saving Tips
• Do not install the appliance near cookers, radiators or other sources of
warmth. High ambient temperatures cause longer, more frequent opera-
tion of the compressor.
• Ensure sufficient air circulation and exhaust at the appliance base and at
the back wall of the appliance. Never cover air vent openings.
• Do not place warm foods into the appliance. Allow warm foods to cool
first.
• Only leave door open as long as necessary.
• Do not set temperature any colder than necessary.
• Keep the heat emitting condenser, the metall grille on the rear wall of
your appliance, always clean.
What to do if ...
Correcting Malfunctions
A malfunction may be caused by only a minor fault that you can rectify
yourself using the following instructions. Do not perform any other work on
the appliance if the following information does not provide assistance in
your specific case.
Warning! Repairs to refrigerators/freezers may only be performed by
qualified service engineers. Improper repairs can give rise to significant
hazards for the user. If your appliance needs repairing, please contact your
specialist dealer or our Customer Service.
Malfunction
Possible Cause
Appliance is not switched on Switch on the appliance.
Mains plug is not plugged in
or is loose.
Appliance does not work.
Fuse has blown or is defective.
Socket is defective.
Appliance cools too much.
Temperature is set too cold.
Remedy
Insert mains plug.
Check fuse, replace if neces-
sary.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature regula-
tor to a warmer setting tem-
porarily..
29
Advertisement
Table of Contents
