Connection Of Power Supply - Electrolux CAL61.206 Installation & Operating Instructions Manual

8.

CONNECTION OF POWER SUPPLY

TO AIR CONDITIONER
WARNING
Be sure power supply is OFF before connecting
power supply leads to the air conditioner.
The electrical installation must be done by an author-
ity electrician.
A. You may either wire direct into the junction box for a
permanent connection or wire a molded plug into the
junction box for a plug-in connection.
If a Permanent Connection:
1.
supply line, previously installed to the roof open-
ing, into the junction box on the ceiling template.
Connect as described in part 8B below.
If a Plua-In Connection:
2.
line, of part 4C3, to power an electrical outlet
installed, according to applicable laws, at the end
of the roof opening furthest from the junction box.
CAUTION: DO NOT plug the molded cord in
until you have completely installed the air
conditioner and are ready for an operational
check (Section 10).
Route the molded plug set from the electric outlet into the
junction box insuring not to coil excess wire so it will block
air flow. Connect the plug set to the terminal block as
described in Section 8B below.
B. Connect the power supply line to the air conditioner at
the terminal block provided in the junction box. Con-
nect red to red, black to black, and green to green or
bare copper wire (P, P, and 4 respectively).
FIG. 8
CEILING TEMPLATE
POWER SUPPLY
(FIG. 8)
NOTICE
Route the power
Use the electric supply
BOTTOM VIEW
JUNCTION BOX
C. Tighten the strain relief onto the power supply line, to
hold it firmly in place.
NOTE: If optional Electric Heater is part of this installa-
tion, now is the time to install it. Installation
Instructions are provided with the Electric Heater
Kit.
D. Carefully push all excess wire back into the junction
box and install cover onto the box with two blunt tipped
screws provided.
E. Plug the electrical conduit from the upper unit into the
mating switch box connector.
SWITCH
BOX
9
ELECTRICAL
CONDUIT