Table of Contents
Advertisement
Enabling enclosure or server indicators by using the ASMI
Find out how to enable enclosure or server indicators by using the Advanced System Management
Interface (ASMI).
About this task
To perform this operation, you must have one of the following authority levels:
v Administrator
v Authorized service provider
To enable the enclosure or server indicator states, complete the following steps:
Procedure
1. On the ASMI Welcome pane, specify your user ID and password, and click Log In.
2. In the navigation area, expand System Configuration > Service Indicators > Enclosure Indicators. A
list of enclosures is displayed.
3. Select the enclosure and click Continue. A list of location codes is displayed. Alternatively, you can
click Indicators by Location Code and type the location code in the Location code field.
4. In the Identify indicator status field, select Identify.
5. To save the changes that are made to the state of an indicator, click Save settings.
Starting the system
Learn how to start a system after performing a service action or upgrading a system.
Starting a system that is not managed by an HMC
You can use the power button or the Advanced System Management Interface (ASMI) to start a system
that is not managed by a Hardware Management Console (HMC).
Starting a system by using the control panel
You can use the power button on the control panel to start a system that is not managed by a Hardware
Management Console (HMC).
Procedure
1. Open the front rack door, if necessary.
2. Before you press the power button on the control panel, ensure that power is connected to the system
unit as follows:
v All system power cables are connected to a power source.
v The power LED (A), as shown in the following figure, is flashing.
3. Press the power button (A) on the control panel, as shown in Figure 26 on page 30.
Common procedures for installing, removing, and replacing the PCIe3 6-slot fanout module
29
Advertisement
Table of Contents
