Figure 2. Placing the cable management bracket in the raised service position
Installing a PCIe3 6-slot fanout module in the EMX0 PCIe3 expansion
drawer
To install a PCIe3 6-slot fanout module in the EMX0 PCIe3 expansion drawer, complete the steps in this
procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Remove the filler.
3
PCIe3 6-slot fanout module