Advertisement
9.
Feed the power cord through the second strain
relief from the side into the contactor box.
10. Attach the two outside leads from the power cord to
the right side of the compressor contactor.
11. Remove the top ground nut from the ground stud.
Slip the ring of the middle ground lead over the
ground stud and secure it by tightening the ground
nut.
12. Pull the slack out of the power cord through the side
of the contactor box and tighten the strain relief on
the contactor box.
13. Pull the slack out of the power cord through the
back of the unit and tighten the strain relief on the
outside of the unit.
14. Replace the cover to the contactor box.
15. Replace the back panel and left side panel.
© 2003-2014, Cornelius Inc.
FCB Cord Kit for V-Series 4 Flavor Installation Instructions
- 3 -
Publication Number: 629088373INS
Advertisement
