Wolf MGK-2-390 Installation Instructions Manual page 6

Warnings:
- The condensate pan should only be changed by a specialist
- Check for gas leaks after installation
- There is a risk of poisoning from gas leaks if installed incorrectly
Contents set for changing the condensate pan
•
Condensate pan
• Silirub silicone in box in the condensate pan
• Seal between condensate pan and flue pipe, installed in condensate pan
• 12 or 8 grub screws for the service cover, installed in the condensate pan
• Condensate pan service cover, installed
• Condensate drain connection, installed in condensate pan
• Hose nipple for flue gas pressure switch, installed in condensate pan
• Adapter for flue gas temperature sensor with O-ring and peg in bag with installation instructions
Equipment/tools required to change the pan:
•
2 x jack (height 500mm)
• Sandpaper
• Brake cleaner or silicone remover
Remove the casing
- Removing the burner and plate
- Removing the front casing, cover and rear panel
Unscrew condensate pan
6
Changing the condensate pan MGK(-2)-390-1000
3065732_201806