Before Using For The First Time; Operating Instructions - Westinghouse WST4015ZE Owner's Manual

BEFORE USING FOR THE FIRST TIME

1. Boil a Kettle of water following the Operating Instructions below.
Discard the water.

OPERATING INSTRUCTIONS

CAUTION: Do not immerse Power Base, power cord, or plug
in water or any other liquid.
1. Place Power Base on a level surface such
as a countertop or table.
The Power Base must be dry before use.
2. Raise the ON/OFF Lever into the OFF
position. (See Figure 2.)
3. Remove Kettle from the Power Base by
lifting up.
4. Open the Lid by pressing down the Lid
Release Button under the handle. (See
Figure 3.) Fill the Kettle with the desired
amount of water while continuing to press
the Button. DO NOT fill ABOVE the MAX
level or BELOW the MIN level as indicated
on the Water Window. Release Button to
lower Lid. Wipe excess water off the Kettle.
CAUTION: Do not fill above the MAX
water level. This could cause boiling
water to splatter out.
NOTE: If the Kettle is accidentally
switched ON without sufficient water,
a boil-dry protection device will
automatically turn the unit OFF.
(See boil-dry protection explanation.)
NOTE: If the Lid is not properly closed,
the Kettle will not automatically
shut OFF.
CAUTION: To avoid the risk of splashing
while pouring hot water, make sure
the Lid is securely closed onto the
Kettle before operation.
5. Place the Kettle on the Power Base,
engaging the connector into the bottom of
the Kettle. Be careful not to spill any water
onto the Power Base.
5
Figure 2
Figure 3