Melitta ME1MSB Manual page 26

7. Press the ON/OFF Button to turn the Coffee Maker ON again.
Allow the vinegar/water solution to cycle through the Coffee
Maker. When the brew cycle is finished, press the ON/OFF
Button to turn the Coffee Maker OFF and discard the
vinegar/water solution.
8. To rinse: Allow the Coffee Maker to cool for 15 minutes. Fill the
Carafe with cold fresh water. Pour the water into the Water
Reservoir. Replace the Carafe onto the Warming Plate and press
the ON/OFF Button. When the brew cycle is complete discard
the water. Repeat with another Carafe of fresh water. Discard the
rinse water.
9. Wash and dry all removable parts. Wipe the exterior of the
Coffee Maker with a damp cloth.
WARNING: Changes or modifications to this equipment
not expressly approved by the party responsible for
compliance could void the user's authority to operate
the equipment.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is needed.
• Consult the dealer or an experienced radio/TV technician
for help.
24