Water Filter - Melitta ANDMECF10 Use And Care Manual

WATER FILTER

This unit features an optional charcoal water filter to provide optimum taste and
removal of most of the chlorine from tap water, along with other metals and
particles often found in tap water. To insert the charcoal filter, remove the lid of
the water chamber. Take the water chamber by the handle and lift directly up
and out. Turn filter holder counter clockwise until it releases. Place charcoal
filter in water filter holder, aligning arrow on chamber with tab on holder, push
up and turn clockwise, (see figure 2). Reposition chamber in coffeemaker
aligning tabs on chamber and grooves in coffeemaker, replace lid. The water
will be filtered when poured either directly through the water chamber or
through the frontal water fill. Filters should be replaced either after 60 uses or 6
weeks (whichever occurs first) and can be ordered direct from Toastmaster by
calling toll-free 1-800-947-3744 or 1-800-947-3745.
Each charcoal water filter comes with a set of monthly stickers to attach to the
label located on the water chamber lid. Write day next to month, this will allow
you to keep track when you started using the water filter.
If you use spring or bottled water or your water contains only a small amount
of chlorine, you may not notice a difference in the taste of your coffee when
using the filter.
BREWING
1. Make sure unit is in the OFF position O, (top of switch pushed in), the
indicator light will be off.
2. Plug into 120 V ~ 60 Hz outlet.
3. Lift up the hinged water fill lid located at the front of unit and slowly add
cold water to desired level using the water level indicator (between 3-
10 cups). Brewing less than 3 cups or 15 ounces is not recommended.
You may also pour water directly into the charcoal filter chamber. Both
filling methods allow water to pass through the charcoal water filter.
4. Make sure that carafe with lid is properly seated on warming plate.
5. Open swing out filter basket. Insert a #2 cone-shaped paper filter into
removable liner and add coffee grounds. Return basket to closed
position; it will click into place. Use approximately 1 measuring spoon of
grounds for every cup of coffee.
6. Press bottom of switch to ON position I. The indicator light will turn on.
7. If you wish to serve a cup of coffee before brew cycle is complete,
"Pause and Pour," simply remove carafe from warming plate. Dripping
will automatically cease. Return carafe to position on warming plate
within 30 seconds; dripping will resume.
Note: If the carafe is not returned to the warming plate, the coffee will
overflow from the filter basket.
8. Warming plate will automatically cycle to maintain serving temperature
as long as switch is on.
9. Press top of switch to OFF position O when carafe is empty or not in
use. The indicator light will turn off.
10. Unplug and allow to cool for 10 minutes between cycles.
IMPORTANT: If not allowed to cool before immediate repeated use, water
placed in water chamber may become overheated. A spray of steam could be
released from openings, creating a risk of burns.
4