Panasonic CF-20 Series Operating Instructions And Reference Manual page 45

The password you set in the Setup Utility will be requested upon resuming from hibernation (but not from sleep), if [Password On
Resume] is set to [Enabled] in the [Security] menu of the Setup Utility. To disable it, set [Password On Resume] to [Disabled].
The [Password On Resume] setting is valid when you shut down the computer by clicking
It may take 1 or 2 minutes to enter hibernation. Do not touch any key though the screen becomes dark.
The following problems will occur when you fail the password input (failing three times or leaving the computer unattended for one minute or more) while
resuming from sleep or hibernation.
Failing the password input while resuming from hibernation:
n
Cannot resume from hibernation by the Task Scheduler or the operation to open the display.
Entering/Resuming from Sleep or Hibernation
To enter sleep or hibernation
In order to enter sleep or hibernation by following procedure, change the power option settings first so that the [Power buttons and lid] operation is set to
sleep or hibernation. ( Setting Sleep or
Using hardware functions
1. Close the display, or press the power switch (A).
Sleep: The power indicator (B) blinks green.
Hibernation: The power indicator (B) goes off.
Using ≪Fn≫
You can also enter sleep or hibernation using ≪ Fn≫ .
( Key Combinations)
Using Windows function
You can alternatively enter sleep using Windows function.
1. Click (Start) -
2. Click [Sleep].
N O T E
Hibernation from the Windows system menu is not available as the factory default. To enter hibernation from the Windows system
n
menu, the following setting is necessary.
C A U T I O N
Hibernation)
(Power).
(Start) - [Power] - [Shut down].