Host Id Setting Switches (Host-Id) - Toshiba V Series Operation Manual

3.1.2

Host ID setting switches (HOST-ID)

The product has in it the hexadecimal rotary switches that are used to set a host ID to
determine an IP address on the Ethernet. Set a host ID in the range of 1 to 126 allocated
to a system during the process of its building, using HEX (hexadecimal) code. Allocate
an address different from others in value to each of the nodes in the system. (See
Appendix D Decimal-hexadecimal Conversion Table.)
Use a small screwdriver for setting them.
Name
Host ID
Note: (h) means hexadecimal
H
6F8C0878
Table 3-1 Host ID Setting
Location
H Set value: 01 to 7E (h)
L H (High address): 0 to 7 (h)
L (Low address): 0 to F (h)
Set a host ID in HEX (hexadecimal code).
If the address is 28, for example, it corresponds to
L
1C in hexadecimals.
Therefore, set the H rotary switch to 1 and the L to
C.
Class C (general) corresponds to 172.16.64.28 in
this example.
Figure 3-2 Host ID Setting
Setting Default (before shipment)
01 (h)
or a value determined for
the system
3.1 Switch Setting
3
15