Table of Contents
Advertisement
3. SIF PCB ADJUSTMENT
3-1. SIF PCB ADJUSTMENT
1) Pattern : PAL B/G Color BAR 400Hz Mono
2) Use the ' MENU' key and check the Sound broadcast system is "AUTO".
3) Press the ' S11' key of Service Remocon to set the "2-Picture" mode.
4) Connect the probe of Oscilloscope to PS602(Left & Right).
5) Adjust SIF coil(L105) to make the display of Oscilloscope be sine curve.
6) Press the ' S11' key of Service Remocon twice to cancel the "2-Picture" mode.
4. GEOMETRIC ADJUSTMENTS
4-1. GEOMETRIC ADJUSTMENT : VERTICAL
4-2. VERTICAL CENTER ADJUSTMENT
1) Pattern : PAL B/G Monoscope
2) Press the
3) Choose the "VSH" using the ' PR UP' , ' PR DOWN' keys.
4) Adjust the horizontal line of picture to coincide with the
mechanical center marks of the CRT using the ' VOLUME UP' , ' VOLUME
DOWN' keys.
* If the pattern is smaller than the screen, adjust the V-size to fit.
4-3. VERTICAL SIZE ADJUSTMENT
1) Pattern : PAL B/G Monoscope
2) Press the
key to set the "STANDARD" mode.
3) Choose the "VA" using the ' PR UP' , ' PR DOWN' keys.
4) Adjust the upper part of the picture using the ' VOLUME UP' ,
' VOLUME DOWN' keys.
4-4. VERTICAL SLOPE ADJUSTMENT
1) Pattern : PAL B/G Monoscope
2) Press the
key to set the "STANDARD" mode.
3) Choose the "VS" using the ' PR UP' , ' PR DOWN' keys.
4) Adjust the lower part of the picture using the ' VOLUME UP' , ' VOLUME DOWN' keys.
HORIZONTAL
key to set the "STANDARD" mode.
SERVICE REMOCON ' S4'
SERVICE REMOCON ' S5'
- 8 -
Advertisement
Table of Contents
