Parameterize
9.2 Parameterizing the operator interface
9.2.11
PAC RS485 expansion module
PAC RS485 expansion module
If the PAC RS485 expansion module is plugged in, the device setting "RS485 MODULE" is
executed in the "SETTINGS" menu.
Call: "SETTINGS > RS485 MODULE".
RS485 MODULE
ADDRESS
BAUD RATE
SETTINGS
PROTOCOL
RESPONSE TIME
9.2.12
Password management
9.2.12.1
Introduction
Note:
The default password is:
0000
If no user-specific password has been assigned, the default password must be entered when
password protection is switched on.
9.2.12.2
Calling password management
You can find password management in the device settings under
"ADVANCED > PASSWORD"
To access password management:
1. Exit the measured value display. Call the "MAIN MENU":
F4
2. In the main menu, go to the "SETTINGS" entry:
F2
3. Call the "SETTINGS" entry:
F4
4. In the "SETTINGS" menu, go to the "ADVANCED" entry:
F2
5. Call the "ADVANCED" entry:
F4
6. In the "ADVANCED" menu, call the "PASSWORD PROTECTION" entry:
F4
150
Default values of the device
or F3
or F3
126 (adjustable range: 0-126)
19200
8N2
MODBUS RTU
0 ms
SENTRON PAC3200
Manual, 02/2008, A5E01168664B-04