Installation - DeLonghi TCH8093ER Instructions For Use Manual

INTRODUCTION
Thank you for choosing a De'Longhi product.
Please take a few minutes to read these instructions.
This will avoid all risks and damage to the appliance.
Symbols used in these instructions
Important warnings are identified by the symbols below.
It is important to respect the warnings. Failure to respect
the warnings could lead to electric shock, serious injury,
burns, fire or damage to the appliance.
Danger!
Failure to observe the warning may result in life
threatening injury by electric shock.
Important!
Failure to observe the warning could result in injury or
damage to the appliance.
Danger of burns!!
Failure to observe the warning could result in burns or
scalds.
Please note:
This symbol indicates recommendations and important
information for the user.
Safety functions
- Safety device: the appliance is fitted with a safety
device which switches it off in the event of accidental
overheating (e.g. obstruction of air intake and outlet
grilles, motor turning slowly or not at all). To reset,
unplug the appliance from the mains socket for a few
minutes, remove the cause of overheating then plug
in again.
Tip over safety device: a tip over safety device
-
turns the appliance off if it falls over or is positioned
inappropriately in such a way as to jeopardise safety.
The appliance emits a beep and a dot flashes on the
display. The appliance resumes operation a few se-
conds after being placed in an upright position again.
DESCRIPTION
(see fig. 1)
A
ON/STAND-BY button
B
+/- adjustment buttons
C MODE button (selects the operating mode)
D "ECO plus" button
E Timer button
F Swing button
G Remote control receiver
H Indicator light
I Air intake grille
J Filter
USE

Installation

- The appliance can be used on any horizontal surface.
Do not overload the electrical circuit. Avoid using the
same socket for other appliances.
Electrical connection
- Before plugging the appliance into the mains socket,
check that the mains power supply corresponds to
the value indicated on the rating plate and that the
mains power supply is adequate for the load.
- THIS APPLIANCE COMPLIES WITH DIRECTIVE
2004/108/EEC
SUPPRESSION.
Mounting the base
- Fit the two parts of the base together, matching the
guide pins on the front with the recesses on the back
and snapping the two clips into place (fig. A and fig. B).
- Turn the appliance upside down and position the
assembled base on the appliance in order to couple
the two openings with the two tabs on the appliance,
tilting it as shown in figure C, consequently turn the
base down till the two frontal teeth snaps into position.
Operation and use
1. Plug into the mains socket.
2. The appliance emits a beep. The indicator light (H)
comes on and remains lit while the appliance is
powered.
3. The appliance switches to stand-by. A dot flashing
on the display means the tip over device has been
activated. See paragraph: "Safety functions".
4. Press the ON/STAND-BY (A) to turn the appliance on.
It begins heating the room according to the current
settings.
5. Press the MODE button (C) to select one of the
following operating modes:
Fan
Freeze prevention
Heating 1
4
ON RADIO INTERFERENCE