Extracción De La Placa Base; Requisitos Previos; Procedure - Dell XPS 13 Service Manual

Extracción de la placa base
AVISO: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in
inside your
instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
NOTA: Your computer's Service Tag is stored in the system board. You must
enter the Service Tag in the BIOS setup program after you replace the
system board.
NOTA: Replacing the system board removes any changes you have made to
the BIOS using the BIOS setup program. You must make the appropriate
changes again after you replace the system board.
NOTA: Before disconnecting the cables from the system board, note the
location of the connectors so that you can reconnect the cables correctly
after you replace the system board.

Requisitos previos

1 Extraiga la cubierta de la
2 Extraiga la batería.
3 Extraiga la tarjeta
4 Extraiga la unidad de estado
5 Extraiga el disipador de

Procedure

1 Peel off the tape that secures the antenna cables and power-adapter port cable
to the system board.
2 Disconnect the camera cable, touchscreen cable (optional), power-adapter port
cable, and coin-cell battery cable from the system board.
70
computer. After working inside your computer, follow the
After working inside your
base.
inalámbrica.
sólido.
calor.
Before working
computer. For more safety best
www.dell.com/