ECS K7VTA3 Manual page 41

SuperIO Device
Scroll to this item and press <Enter> to view the following screen:
Phoenix – AwardBIOS CMOS Setup Utility
POWER ON Function
KB Power ON Password
Hot Key Power On
Onboard FDC Controller
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
ECP Mode Use DMA
Power On After Power Fail
↑ ↓ → ← : Move
Enter : Select
F5:Previous Values
POWER ON Function (Hot KEY)
This feature allows you to set the method by which your system can be turned
on.
KB Power ON Password (Enter)
When the POWER ON Function is set to Password, use this item to set the
password.
HotKey Power On (Ctrl-F12)
When the POWER ON Function is set to Hot KEY, use this item to set the hot
key combination that turns on the system.
Onboard FDC Controller (Enabled)
Select Enabled if your system has a floppy disk controller (FDC) installed on
the system board and you wish to use it. If you install an add-in FDC or the
system has no floppy drive, select Disabled in this field.
Onboard Serial Port 1 (3F8/IRQ4)
Select a logical COM port name and matching address for the first and sec-
ond serial ports. Select an address and corresponding interrupt for the first
port.
Onboard Parallel Port (378/IRQ7)
This option is used to assign the I/O address and interrupt request (IRQ) for
the onboard parallel port.
Parallel Port Mode (ECP)
Enables you to set the data transfer protocol for your parallel port. There are
four options: SPP (Standard Parallel Port), EPP (Enhanced Parallel Port),
ECP (Extended Capabilities Port), and ECP+EPP.
SPP allows data output only. Extended Capabilities Port (ECP) and Enhanced
Parallel Port (EPP) are bi-directional modes, allowing both data input and output.
SuperIO Device
[Hot KEY]
Menu Level
[Enter]
[Ctrl-F12]
[Enabled]
[3F8/IRQ4]
[378/IRQ7]
[ECP]
[3]
[Off]
+/-/PU/PD:Value: F10: Save ESC: Exit
F6:Fail-Safe Defaults F7:Optimized Defaults
37
Item Help
F1:General Help