Table of Contents
Advertisement
Before attempting to mount or service your Tiger mower, it is important to
read and understand all of the information in the Safety section of this manual.
Check complete shipment list against the packing list to make sure there are no
shortages. Make certain the tractor model is the appropriate one for the mower
received!
Use a floor jack, hoist or fork lift to lift or raise heavy parts whenever
possible whether mentioned or not.
Read and understand the entire assembly section instructions before attempting to
mount your Tiger mower. Refer to the parts section of this manual for detailed
illustrations to locate all parts.
TRACTOR PREPARATION
A: Remove right and left hand steps.
B: Disconnect cables from both batteries, (remove batteries and the battery
box from cab units only.)
C: Remove engine side panels, or raise hood to access front pulley.
D: Remove plugs from tractor casting where main frame and pump mount will be
attached.
E: Raise the tractor onto jack-stands and remove the right and left rear wheels.
CRANKSHAFT ADAPTER
If necessary remove the four cap-screws from the crankshaft pulley. Then install
the crankshaft adapter and spacer to the pulley with cap-screws and lock-washers
as shown in the parts section
ASSEMBLY
Assembly Section 2-2
12-10-01
Advertisement
Table of Contents
