Related Manuals for Tronic KH 3905
Summary of Contents for Tronic KH 3905
- Page 1 Power Inverter KH 3905 Power Inverter Operating instructions KOMPERNASS GMBH BURGSTRASSE 21 · D-44867 BOCHUM www.kompernass.com ID-Nr.: KH3905-01/10-V3...
- Page 2 KH 3905 ‚ „...
-
Page 3: Table Of Contents
INDEX PAGE Intended Use Safety information Technical data Operating Elements Initial operation Operational information Connection and operation of a load/device Device operation information Low battery signal Changing the cable fuse Handling general failures Troubleshooting Cleaning Disposal Importer Warranty & Service Read the operating instructions carefully before using the device for the first time and preserve this booklet for future reference. -
Page 4: Intended Use
POWER INVERTER • Only connect the power inverter to the automotive KH 3905 battery when the engine is switched off! The possibility of injury exists from rotating parts! • Check the device and all parts for visible damage. Intended Use The safety concept of the device can only function properly when it is in perfect condition. -
Page 5: Technical Data
Technical data This device suitable only for use indoors. Risk of fire! DC Input • Do not use the device near hot surfaces. • Do not locate the device in places exposed to Voltage: 12 V direct sunlight, Otherwise, it may overheat and Maximum voltage: 15,6 V become irreparably damaged. -
Page 6: Operating Elements
Operating Elements Operational information For continuous operation of devices via the power Power inverter: inverter the vehicle socket must supply a voltage Fan (on the rear panel) between 11 - 15,5 V . The voltage source of Operation LED/Overload indicator the vehicle socket can be perhaps an automotive On/Off switch battery or a regulated DC voltage like a transformer-... - Page 7 Setup • The power inverter should be positioned on an even, flat surface. Make sure that there is 1 cm free space remaining all around the power inverter for air circulation. • A distance of 50 cm must be maintained behind the fan's ventilation slots.
-
Page 8: Connection And Operation Of A Load/Device
Connection to an automobile battery • Switch the power inverter on by moving the on/off • Loosen the red screw on the power inverter as switch to the position I. If the power inverter much as is needed for you to be able to place is functioning properly the operation LED/Over- the red cable shoe of the red cable with the load indicator... -
Page 9: Low Battery Signal
• Inductive loads, for example, televisions or stereo The red cable with the connection terminal systems (devices with an inductor or a transformer) equipped with a fuse. When too great a load is often require a much greater switch on current connected to the power inverter the fuse will blow. -
Page 10: Handling General Failures
Handling general failures Low battery voltage signal sounds continually Electrical tools Possible cause and remedy: • When an electrical tool will not switch on or only • The battery is defective. Replace the battery. runs for a short time switch the power inverter on •... -
Page 11: Cleaning
Cleaning Importer KOMPERNASS GMBH Risk of potentially fatal electrical BURGSTRASSE 21 shock: D-44867 BOCHUM • Never submerse the device in water or other www.kompernass.com liquids! • Do not allow any liquids to penetrate the Warranty & Service housing. • Before every cleaning remove the power in- The warranty for this appliance is for 3 years from verter from the vehicle receptacle/remove the the date of purchase.