Problems With Windows Setup - NEC Bull NovaScale R620 Series Setup Manual

Problems with Windows Setup

The following message is displayed when the setup starts.
The specified disk is not found. Terminating SW
→
The disk to install the system is not connected properly. Check if the hardware is properly installed and
connected.
The following message is displayed while copying files from CD-ROM.
xxxxx : Not Ready xxxxxxxxxxxxxxxxxxZ
xxxxx(A), xxxxx(R), xxxxx(F)
→
Press R. If this message still appears, perform the setup again. If the error persists, contact your sales agent
to examine the CD-ROM drive.
Failed to setup in detail for network adapter.
→
The detailed setup of network adapter is not available in setup of NovaScale/Fault Tolerant Server series.
Open the control panel after starting Windows Server 2003 to configure the network adapter.
Failed to install Windows Server 2003 correctly.
Have you checked instructions and information on installation?
→
See "Step 1: Things Required for Setup" (page 4-4) and "Step 2: Prepare for Express Setup" (page 4-6).
Rebooted during the setup.
→
See "Step 3: Disable Boot Monitoring Function" (page 4-9), and set the parameter of this machine's boot
monitoring function to correct value.
GeminiEngine Control Software UPDATE CD-ROM is not included.
→
GeminiEngine Control Software UPDATE CD-ROM is used to update GeminiEngine Control Software; i
may not be shipped with the equipment. (Not included if "EXPRESSBUILDER" CD-ROM contains the
latest version of software programs at the time of shipment). For the latest release of GeminiEngine Con
Software and purchase of th
contact your sales agent.
During a setup, "Previous Operating System C:" was selected on a selection screen of the operating system.
→
The process will be stopped along the display of DOS prompt or black screen. In this case, press Ctrl
+ Delete, or turn off the power to reboot the system. Installation will be continued after a reboot.
Windows can b e operated after a setup but each module or PCI board is not duplicated. (FT Status LED does not
light gre n). e
Did you abort the installation during a setup such as by closing a window of the programs that are running
→
Installation will be aborted if you finish the programs that are running such as by closing a window.
Although the operation on Windows will be feasible, PCI boards will not be duplicated properly if you abort
the installation. In this case,
DISK cc A ess LED will light amber.
Did you properly setup the duplex of HDDs?
→
DISK Access LED will light amber, if a setup for duplex is not performed. (See "LEDs" in the separate User
Guide for details about t
the duplex of HDDs.
NovaScale R620-LR / R620-MR Setup Guide
e latest version of its GeminiEngine Control Software UPDATE CD-ROM,
"Step 1: Things Required for Setup" needs to be done from the beginning.
he indication status of LED.) See "Step 6: Set Dual Disk Configuration" and set up
6-13
t
trol
+ Alt
?