Door Sealing; Troubleshooting; If Refrigerator Does Not Cool Correctly In Dc Mode - Norcold N10DC Series Owner's Manual

Door sealing:

If the door does not seal correctly, excess frost will collect inside the refrigerator. Make sure the door seals correctly:
- Close the door on a piece of paper that is about the size of a dollar bill (See Art00980).
- Gently pull the paper.
- You should feel a slight drag between the gasket and the cabinet.
- Do this on all four sides of the door.
- If you do not feel a slight drag on the paper, the door is not sealing correctly.
- Have your dealer or an authorized Norcold Service Center correct the seal of the
door.
Refrigerator Storage:
Before the refrigerator is stored for an extended (seasonal) period of time:
- Defrost and clean the interior of the refrigerator
- Leave doors open or cracked

Troubleshooting

If the refrigerator does not cool correctly in DC mode:
- Make sure the
power switch is not in the OFF position.
- Make sure the compartment control is at the temperature setting that you wish.
- Make sure that the power source to the refrigerator is serviceable.
- Make sure that the fuse or circuit breaker is intact (See "Over current protection system")
- Make sure that the refrigerator is correctly installed and that the built in vents are not blocked.
- Make sure that the ambient temperature is not unusually high (more than 110° F. / 43° C.) (See "Over heating shut-off device
operation").
- Make sure that the doors are closed.
- Make sure that the door gaskets are sealing correctly.
- Make sure that the air circulation inside the refrigerator is not decreased by foods or by shelves that are covered with plastic, paper,
etc.
- Make sure that hot foods were not placed in the fresh food compartment of the refrigerator.- Make sure that the freezer is
defrosted.
After you make these checks, if the refrigerator does not operate, contact your dealer or an authorized Norcold Service Center.
Art00980
Owner's Manual 9