All installations and services must be performed by qualified service personnel.
DIAGNOSTIC FEATURES
The 50V61 control used on this furnace continuously monitors its operation and the operation of the
system.
If the sensed failure is in the system (external to the control), the red LED will flash in the following flash-
pause sequences to indicate failure status (each flash will last approximately 0.25 seconds, and each
pause will last approximately 2 seconds):
1 flash, then pause
2 flashes, then pause
3 flashes, then pause
4 flashes, then pause
5 flashes, then pause
6 flashes, then pause
7 flashes, then pause
8 flashes, then pause
9 flashes, then pause
Continuous flash
The LED will also flash once at power-up.
A green LED indicator is also present to obtain an estimate of the air flowrate (in CFM) produced by the
house air blower. This LED cycles regularly by providing a constant light, followed by a sequence of
flashes. Each flash can be translated to programmed CFM by using the following:
1 flash per 100(programmed) CFM
: Power must be disconnected before servicing.
system lockout (retries or recycles exceeded)
low pressure switch stuck closed
low pressure switch stuck open
open high temperature limit switch
not used
115 V AC power reversed
low flame sense signal
check igniter or improper ground
high pressure switch stuck open
flame sensed with gas valve de-energized
42