Step 2: Cabinet Preparation ............................................... 3 - Thermador PRO-GRAND PD30 Installation Instructions Manual

ELECTRICAL SUPPLY
Installation of the range must be planned so that the
rough-in of the junction box for the receptacle or
conduit connection will allow maximum clearance to
the rear of the unit.
When the power supply cord (not supplied) or conduit
is connected to the mating receptacle or junction box
cover, the combined plug/receptacle or junction box
cover/conduit connector should protrude no more
than 2-1/4" from the rear wall. See Figure 3B.
FIG. 3B WALL CONNECTION
Power Cord & Receptacle
Step 2: Cabinet Preparation
7
This is especially critical if the junction box in the wall
will be directly behind the junction box on the unit
when the unit is installed. Refer to Figure 8 on Page
14 for location of junction box on unit. To minimize
binding when the unit is connected to the receptacle
or junction box, orient the receptacle or conduit con-
nector, and slide back into position.
Junction Box & Conduit