Appendix III-Dispenser kit Installation
1. Turn off the power switch.
2. Unwrap the PC bag of dispenser kit to take out the screw, the
shaft, the plastic roller, the dispenser bar, the direction label and
the peeler sensor cable.
3. Take off the top cover of the printer.
4. Fix the sensor board on the top cover and secure the screw.
Keep the cable at the left.
5. Rout the peeler sensor cable through the guides along the left
side of the top cover.
Screwe
Sensor Cable
CableCable
6. Release the two screws at the bottom of the base housing shown
in Figure 6.1 to 6.3.
7. Remove the middle cover.
8. Take off the H cover.
Figure 6.5
OS-2130D & OS-2130DE User's Manual
70
Top Cover