Mounting The Logo! Into Knx - Siemens LOGO! 8 Manual

2 Setup and description
2.4

Mounting the LOGO! into KNX

The LOGO! 8 is mounted into a KNX system via the LOGO! communication
module CMK2000.
In this, you can define the communication channels in LOGO! CMK2000 from the
LOGO! to the KNX and vice versa. For the channels, you parameterize inputs and
outputs, flags or variable memories as signal in the LOGO!.
The following table shows the signals of the LOGO! for this application example
and the communication direction between LOGO! and KNX.
Table 2-4: Signal exchange between LOGO! and KNX
Signals in
the LOGO!
Output Q1
Flag M50
Flag M51
For the sake of completeness, chapters
configuration of the LOGO! CMK2000 and the integration of the LOGO! signals via
the ETS5 software. If you want to commence operation with the already configured
LOGO! CMK2000 from the supplied ETS5 project, follow the instructions from
chapter 3.4.
Time Switch Function
Entry ID: 109745699, V1.0,
Group address
in KNX
LOGO! → KNX
1/1/1
KNX → LOGO!
1/1/2
KNX → LOGO!
1/1/3
04/2017
Direction
Status LED A1 at KNX button for
the display of the time switch
function as substitute for an
additional switch actuator.
Button A! at KNX button for
central switching on.
Button A2 at KNX button for
central switching off.
2.4.1 and 2.4.2 describe the steps for the
Description
15