Using The Show Version Or Show Hardware Commands - Cisco PA-E3 Series Installation And Configuration Manual

Serial port adapter
Hide thumbs Also See for PA-E3 Series:
Table of Contents

Advertisement

Chapter 4
Configuring the PA-E3

Using the show version or show hardware Commands

Display the configuration of the system hardware, the number of each interface type installed, the Cisco
IOS software version, the names and sources of configuration files, and the boot images, using the show
version (or show hardware) command.
Note
The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
The following sections provide output of the show version command for some of the supported
platforms:
Catalyst RSM/VIP2 in Catalyst 5000 Family Switches—Example Output of the show version Command
Following is an example of the show version command from a Catalyst 5000 family switch with a PA-E3
installed:
Switch# show version
Cisco Internetwork Operating System Software
IOS (tm) C5RSM Software (C5RSM-JSV-M), Version 11.2(9)P
Copyright (c) 1986-1997 by cisco Systems, Inc.
Compiled True 24-Jun-97 17:09 by biff
Image text-base: 0x600108E0, data-base: 0x6095E000
ROM: System Bootstrap, Version 11.2(15707)
BOOTFLASH: C5RSM Software (C5RSM-JSV-M), Version 11.2
Router uptime is 17 hours, 17 minutes
System restarted by reload
System image file is "c5rsm-jsv-mz.7P", booted via tftp
cisco RSP2 (R4700) processor with 32768K bytes of memory.
R4700 processor, Implementation 33, Revision 1.0
Last reset from power-on
G.703/E1 software, Version 1.0.
SuperLAT software copyright 1990 by Meridian Technology Corp).
Bridging software.
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
TN3270 Emulation software.
1 C5IP controller (15 Vlan).
2 MIP controllers (4 E1).
1 VIP2 controller (2 E1)(4 Token Ring).
6 Channelized E1/PRI ports.
OL-3502-04
Catalyst RSM/VIP2 in Catalyst 5000 Family Switches—Example Output of the show version
Command, page 4-15
Catalyst 6000 Family FlexWAN Module—Example Output of the show version Command, page
4-16
Cisco 7100 Series Routers—Example Output of the show version Command, page 4-16
Cisco 7200 Series Routers, Cisco 7200 VXR Routers, and Cisco uBR7200 Series
Routers—Example Output of the show version Command, page 4-17
Cisco 7201 Router—Example Output of the show version Command, page 4-18
Cisco 7401ASR Router—Example Output of the show version Command, page 4-18
VIP in Cisco 7000 Series Routers and Cisco 7500 Series Routers—Example Output of the show
version Command, page 4-19
PA-E3 Serial Port Adapter Installation and Configuration
Checking the Configuration
4-15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pa-2e3

Table of Contents