Cisco PA-E3 Series Installation And Configuration Manual page 86

Checking the Configuration
Catalyst RSM/VIP2 in Catalyst 5000 Family Switches—Example Output of the show interfaces Command
Following are examples of the show interfaces serial command from a Catalyst 5000 family switch. In
these examples, the eight serial interfaces (0 to 7) are on a port adapter in port adapter slot 1 of a
Catalyst RSM/VIP2; also, most of the status information for each interface is omitted. (Interfaces are
administratively shut down until you enable them.)
Switch# show interfaces serial 1/0
Serial1/0 is up, line protocol is up
Internet address is 10.0.0.1
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive not set
[Additional display text omitted from this example]
Switch# show interfaces serial 1/1
Serial1/1 is up, line protocol is up
Internet address is 10.0.0.1
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive not set
[Additional display text omitted from this example]
Switch# show interfaces serial 1/2
Serial1/2 is up, line protocol is up
Internet address is 10.0.0.2
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive not set
[Additional display text for remaining interfaces omitted]
Catalyst 6000 Family FlexWAN Module—Example Output of the show interfaces Command
Following are examples of the show interfaces serial command from a Catalyst 6000 family switch. In
these examples, the serial interfaces are on a port adapter in port adapter bay 1 of a Catalyst 6000 family
FlexWAN module in module slot 8; also, most of the status information for each interface is omitted.
(Interfaces are administratively shut down until you enable them.)
Router# show interfaces serial 8/1/0
Serial8/1/0 is administratively down, line protocol is down
Hardware is Serial
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
Encapsulation HDLC, crc 16, loopback not set
(display text omitted)
Router# show interfaces serial 8/1/1
Serial8/1/1 is administratively down, line protocol is down
Hardware is Serial
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
Encapsulation HDLC, crc 16, loopback not set
(display text omitted)
PA-E3 Serial Port Adapter Installation and Configuration
4-24
Hardware is cyBus Serial
Hardware is cyBus Serial
Hardware is cyBus Serial
reliability 255/255, txload 1/255, rxload 1/255
reliability 255/255, txload 1/255, rxload 1/255
Chapter 4 Configuring the PA-E3
OL-3502-04