Crt; Crt Adaptor; Installation - Texas Instruments TravelMate 2000 User Manual

CRT Adaptor

6-16 TravelMate 2000 Options
The CRT Adaptor (TI Part No, 2568035-000 1) supplies an optional CRT port for your TravelMate 2000.
With this adaptor installed, an analog multi frequency or a VGA monitor with a 15-pin male connector can be
used with your computer.
Note: If the Internal Modem Option is installed in your TravelMate 2000, you must remove it to install
the CRT Adaptor. Store the Internal Modem Option in a bag that protects against electrostatic discharge.

Installation

To install the CRT Adaptor:
1. Remove the battery, as described in Chapter 3.
2. Locate the option card slot cover on the top left of the computer.
Remove the template on the top of the keyboard, to reveal a groove. Hook a small
3.
screwdriver in the groove and open the option card slot cover.
Caution: Prevent possible component damage caused by electrostatic discharge (ESD). Use a
high-impedance, grounded-conductive floor mat or wrist strap to prevent ESD. Before touching the
integrated circuit devices, discharge static electricity from your hands, tools, and containers by
touching them to a grounded surface.