Table of Contents
Advertisement
IR receiver
IR transmitter
Current
measurement
jumper
USB
Power/interface
Figure 2 shows the key layout of the target module with some of the peripheral interfaces
highlighted. For details of the target module features, please see chapter 6.
4.4 Installing RemoTI software and Windows drivers
Before connecting the RemoTI target Module to a PC the required drivers for the tool must be
installed. The latest version of the driver is included with the RemoTI software package. It can
be downloaded from http://www.ti.com/remoTI.
After the software is installed, the driver files are located at this default location:
C:\Texas Instruments\RemoTI\Tools\Driver
For instructions how to install the CC Debugger , please follow the quick start guide included
with the CC Debugger .
The RemoTI software includes drivers for the target module. It is
highly recommended to install this software before you connect the
target module to the PC.
4.5 RemoTI Software
Included with the RemoTI software package is the Target Emulator application. This
application is located at the C:\Texas Instruments\RemoTI\bin folder. The target module is
programmed to be a RF4CE network processor that receives commands from the Target
emulator software and handles the RF4CE protocol
The Target Emulator lets you emulate a remote control on the PC. It displays all messages
sent between the target module and the PC and works in many ways as a system that would
interface to a real life remote control receiver.
The RemoTI software includes RF4CE example software for remote controls and for target
interface. The software is designed to easily allow customized versions of remote controls
and to support a variety of interfaces on the target side.
EM module,
RF reference design
User
Reset
LEDs
Figure 2: Target module layout
9/25
Interface connector
SPI/UART/I2C/IR
Debug/programming
interface
User
button
swru266
Advertisement
Table of Contents
