LG 32LD650H-ZA Installation Manual page 11

(9) Local Key operation
- Decide to operate 'Local Key' or not by setting "Local Key Operation" as Yes(Work) or No(Do Not
Work) .
- When 'Local Key Operation' is set to No(Do Not Work), all Local Key doesn't work except volume up/
down key and power key .
- When 'Local Key Operation' is set to No(Do Not Work), Local Key working in service mode is still
available .
- When 'Local Key Operation' is set to Yes(Work), all Local Key working is available .
- When set both 'Local Key' and 'Remocon Operation' as No(Do Not Work), Power key of Remocon
work as exceptional case .
- Even when the local key operation is set to No, when you press the local key for 5 seconds, the
Menu key will operate to access the Installation Menu .
- Exception : In case of the commercial model, although both IR and Local key operation are set to
'No'(no operation), you can operate the volume +/- key and the power key .
(10) Max Volume
- Decide 'Max Volume' between changing range 0~100 .
- When 'Max Volume' is set, user can change up to set volume value .
- When 'Max Volume' is set, volume just goes up to the 'Max Volume' value in 'On Time Menu' .
(11) power on default
- Set the channel to display and Volume Level, etc . when turn on power in AC Power On or Stand-by
status .
- Set to Yes(Work) or No(Do Not Work) .
- When 'Power On Default' is set to No, it is not applied to the subordinate Programme, Volume, A/V
Setting menu .
- When Power On Default is set to Yes, it can set by entering the subordinate menu .
(11-1) input source
- Set whether it is turned on by the set input source or by the last stored input source .
- It is turned on by the Last Memory Input if the Input source is turned off .
- It is turned on by the Last Pr . If the Input source is turned off and the Last Memory Input is the
RF .
- All sources supported by the said model can be set as Input source . (The Input source value
should be rotated .)
- If both the Input source and the ON TIME are set, the Input source takes the priority .
- If the DTV/Radio Channel does not exist at the map, the DTV/Radio is skipped while navigating .
- When the Input source is changed to the DTV/Radio, the Programme No . is set to the first pro-
gramme of the Channel map of the DTV/Radio .
- When the Input source is changed to the ATV, the Programme No . is set to 0 . (If the channel map
structure does not support this, it follows the structure of the said model .)
(11-2) programme
- If the Input source is DTV or ATV, the set programme is played when the power is turned on .
- Only when the Input source is DTV or ATV, it can be entered into the Programme item .
- When the Input source is turned off, the Last input at the time of the power-off is turned on, and
when the Last input is the RF, the Last programme is played .
- If the Input source is the DTV, the programme number existing at the programme table can be
selected .
- If the Input source is the ATV, 0~(MAX_PR – 1) can be selected . (If the channel map structure
does not support this, it follows the structure of the said model .)
- The programme should be rotated .
- If both the programme and the ON TIME are set, the programme takes the priority .
9