AEG LAVAMAT 82470 BI User Manual page 24

Hide thumbs Also See for LAVAMAT 82470 BI:
Table of Contents

Advertisement

Available languages

Available languages

24 www.aeg.com
cal Service Centre, please carry out the
checks listed below.
During machine operation it is possible
that the yellow pilot light of button 8
blinks, one of the following alarm codes
appears on the display and at the same
time some acoustic signals sound every
20 seconds to indicate that the machine
is not working:
: problem with the water supply
ing
Problem
The appliance does
not start:
The appliance does
not fill:
The appliance fills then
empties immediately:
: problem with the water drain-
ted
Once the problem has been eliminated,
press the button 8 to restart the pro-
gramme. If after all checks, the problem
persists, contact your local Service Cen-
tre.
Possible cause/Solution
The door has not been closed.
• Close the door firmly.
The plug is not properly inserted in the power sock-
et.
• Insert the plug into the power socket.
There is no power at the socket.
• Check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The programme dial is not correctly positioned and
the button 8 has not been pressed.
• Please turn the programme dial and press the but-
ton 8 again.
The delay start has been set.
• If the laundry is to be washed immediately, cancel
the delay start.
The Child safety lock has been activated.
• Deactivate this device.
The water tap is closed.
• Open the water tap.
The inlet hose is squashed or kinked.
• Check the inlet hose connection.
The filter in the inlet hose or the inlet valve filter are
blocked.
• Clean the water inlet filters.
The door is not properly closed.
• Close the door firmly.
The end of the drain hose is too low.
• Refer to relevant paragraph in «Water drainage»
section in «Water drainage» chapter.
: door open
: anti-flooding system has activa-

Advertisement

Chapters

Table of Contents
loading

Table of Contents