Heating Function - DeLonghi TRD Series Manual

Danger of burns!!
- The use of an extension lead is not recommended, as
overheating of the extension lead may occur during the
operation of the heater.
Please note:
- Never use the heater to dry laundry.
- Never place the power cable on top of the heater while
it is hot.
- We recommend that you not place the heater in a
draught, because strong draughts of air may adversely
affect the equipment's operational efficiency.
- Only use the heater in an upright position.
- The heater must be positioned at least 50cm from
furniture or other objects.
- The first time you use the appliance, operate it of at
least 15 minutes with the thermostat at maximum to
eliminate the "new" smell. A little smoke due to the
protective substances applied to the heating element
before transport may be given off.
- Do not obstruct the hot air outlet grilles or the air intake
grille on the bottom of the appliance.
- Position the appliance so that the plug and the outlet
can be easily reached even after installation.
- Do not use the appliance in rooms less than 4 m
- The appliance is fitted with a safety device which will
switch off it in case of accidental overheating.
To reset, please contact Customer Experience, see
enclosed guarantee.
The appliance complies with the following EC
directives:
- Low Voltage Directive 2006/95/EC and subsequent
amendments;
- EEC Directive 2004/108
compatibility (EMC) and subsequent amendments;
Disposing of the appliance
In compliance with European directive 2002/96/
EC, the appliance must not be disposed of with
household waste, but taken to an authorised waste
separation and recycling centre.
DESCRIPTION
A
display
B on-standby button
C power button
D decrease button
E increase button
in area.
2
on electromagnetic
9
F timer button
G
brightness button
H
eco button
I
cord holder
L
wheel
USE
"Easy wheel" system
Turn the radiator upside down on a rug or a soft surface in
order to prevent damaging the paint finish.
Fully unfold the wheels by turning them outwards (Fig. 1).
Turn the radiator back to its upright position.
Location
The heater must not be placed immediately below a power
outlet. Do not use this radiator in rooms having a surface area
of less than 43 square feet (4 sq.m.).
Power connection
- Before using the appliance check that your supply
voltage is the same of that shown on the rating label
of the unit and that the power socket and power supply
line correspond to the load specified.
- Check also the current capacity of your fuses. CONNECT
YOUR HEATER TO EARTH PROVIDED SOCKET ONLY.
- This appliance complies with directive 2004/108/ec on
electromagnetic compatibility.
The appliance will be set in the stand-by condition.
The display will show the
or bedding, furniture and flammable material away from
the power outlet where the heater is plugged in. After an
interruption of the power supply (power failure or appliance
unplugged) the unit goes always to stand-by. When the
unit is switched on by pressing the on-standby button, the
operating conditions will be same ones previously set.

Heating function

To turn the appliance on, press the
Press button (C) to set the required power level:
MIN ( ); MED (
desired temperature, press button + or - (E or D). By pushing
the + or - button once, the temperature (shown on the
display) will increase or decrease by 1°C. Keeping the + or
symbol. Keep loose clothing
(B) button.
); MAX ( ). To select the
Fig. 1