Blodgett Export Series Installation And Operation Manual page 6

Installation
Oven Assembly
NOTE: This appliance shall be installed in accordance
with current regulations and used only in awell-
ventilated space. Refer to the instructions before
installing and using this appliance.
NOTE: Installation must be performed by a qualified in-
staller only.
LEG ATTACHMENT
10 cm legs
1. Lay the oven on its back.
2. Screw the legs into the holes in the oven corners.
Tighten the hex nut at the top of each leg
3. Tip the oven up on the legs.
4. Turn the adjustable leg feet to level the oven.
Figure 1
15 cm, 18 cm and 64 cm legs
1. Lay the oven on its back.
2. Align the threaded stud in each leg with the nut in-
side each bottom corner. Turn the legs clockwise to
tighten.
3. Align the holes in each leg plate with the holes in the
oven frame. Secure each leg with two 1/2" bolts.
NOTE: See Caster Installation if applicable.
4. Tip the oven up on the legs.
5. Turn the adjustable leg feet (or casters) to level the
oven.
4
15 cm Adjustable Legs
Figure 2