Table of Contents
Advertisement
Figure 1-2 2102 Components - Bottom View
Table 1-2 Wireless Module Components - Bottom View
Item No.
1
2
3
4
1.2.2 Communication
Connectors
Description
Communication Connector
Cap
Cap Holder
Latch
When a communication connector is not in use, the con-
nector must always be capped (Figures 1-3 and 1-5). The cap
will seal the connector to prevent corrosion, prevent moisture
from entering the unit, and improve communications.
When a communication connector is in use, store the cap on the
holder next to the connector (Figures 1-4 and 1-6). The communi-
cation connector will be sealed by its mating connector.
Caps PUSH ON and PULL OFF. Do not rotate the caps to
remove them from the connectors.
Note
For modules to correctly stack and lock together, protective
caps between the modules must be stored on the holders.
2102 Wireless Communication Module
Section 1 Quick Start Guide
2
1
3
4
CAUTION
1-3
Advertisement
Table of Contents
