Table of Contents
Advertisement
2102 Wireless Communication Module
Section 3 Preparation and Installation
3.3 Installation
Note that the Wireless
Module must be on
top of the stack.
Carrying Handle
Figure 3-2 Assembling a Basic System
Connecting the Modules
3-2
materials that can withstand harsh environments. However, con-
tinual exposure to UV light, or periodic submersion should be
avoided to extend the life of the components.
Communication between the base and remote modules are rated
for distances as great as
However, obstructions such as buildings and industrial
equipment between the modules may reduce the effective dis-
tance.
Typically, the modules are suspended inside a manhole. Sus-
pending the module near the opening will protect it from the ele-
ments, minimize the chance of submersion, and allow it to be
easily retrieved without entering the manhole. In most instances,
this location near the opening will allow for successful wireless
communication.
Typical communication distances possible using internal
antennas are:
1
• Line-of-sight:
/
mile (0.8 km)
2
• Inside closed manhole: 100 feet (30m)
To connect the 2100 Parameter and Battery modules, refer to the
following instructions and Figure 3-2.
1. On the top of the Battery Module, remove the cap and stow
it on the holder. This exposes the communication connector
on the Battery Module.
1
/
mile (800 meters), line of sight.
2
2102 Wireless Module
21XX Parameter Module
2191 Battery Module
Advertisement
Table of Contents
