Singer 1030 Instruction page 17

REPLACING A WOUND BOBBIN
Raise take-up lever to its highest position.
1. Open slide plate; move bobbin latch all the
way to the left.
2. Draw about an inch of thread from bobbin
and place bobbin in case.
3. Pull thread into bobbin-case slot (point 1),
draw it under flat spring and around to (or
slightly past) point 2, leaving two or three
inches of free thread. (Leave slide plate
open.)
RAISING THE BOBBIN THREAD
Set stitch width dial at .
1. Move bobbin latch to right (sewing posi
tion). Hold needle thread lightly with left
hand and turn hand wheel slowly toward
you so the needle enters plate.
2. Continue turning hand wheel and holding
needle thread until needle rises. Tighten
your hold on the needle thread and bring
up bobbin thread in a loop.
3. Open the loop with your fingers, draw nee
dle and bobbin threads under the presser
foot and place them diagonally to right or
left. Then close the slide plate.
Instrukcje obsługi maszyn do szycia firm Polskich jak i zagranicznych np. Singer Toyota Pfaff Gritzner Łucznik Arka
Replacing a Wound Bobbin
Raising the Bobbin Thread
Step 2
maszynykrawieckie.shophurt.pl
Insert Bobbin
Flat Spring
Draw Thread
Under Flat Spring
Around to Point 2
Step 3
13