Tektronix Phaser 840 Networking Setup Manual page 51

Creating an AppleTalk port
1.
In the Printer Port dialog box, double-click the AppleTalk Printing
Devices port. If the AppleTalk Printing Devices port is not listed in
the Printer Port dialog box, the Microsoft Services for Macintosh needs
to be added to the Windows NT machine:
a.
In the Control Panel, double-click Network; the Network Settings
dialog box appears.
b.
In the Network Settings dialog box, click Add Software; the Add
Network Software dialog box appears.
c. In the Add Network Software dialog box, click the drop down
menu for Network Software. In the list, select Services for
Macintosh, then click OK to install the service. The original
Windows NT distribution diskettes are needed during installation.
To apply these changes, restart Windows NT.
2.
In the Available AppleTalk Printing Devices dialog box, select the
zone where the printer resides. If no zone name appears, double-click
the zone icon.
3. Windows NT searches for all AppleTalk devices in that zone and
displays a list; double-click your printer.
4.
Windows NT prompts you to capture the printer; click No. (Capturing
the printer causes it to disappear from the Chooser.)
Set up sharing
If this printer is to be shared on the network, perform the following steps:
1.
In the Create Printer dialog box, check the option Share this printer on
the network.
2.
Enter any name you want for the Share Name.
7
Windows NT
45
Setup Guide